getting_started:practical_problems:faults_cs
This is an old revision of the document!
Handle Faults in the Control System
When a time domain runs, it can encounter two main obstacles. It could try to read from an unconnected input or it could try to write the value of nan to an output. If either of this happens a fault is thrown. Such a fault will cause the application to stop unless it is properly handled in the control system, e.g. by changing into a safe level, see Time Domains.
sinput not connected, forget to connect nan initial signals = nan, forget to addBlock remove block
getting_started/practical_problems/faults_cs.1527770906.txt.gz · Last modified: 2018/05/31 14:48 by graf