getting_started:practical_problems:start
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
getting_started:practical_problems:start [2017/09/24 16:31] – [Do's] graf | getting_started:practical_problems:start [2017/09/24 16:41] – [Don'ts] graf | ||
---|---|---|---|
Line 3: | Line 3: | ||
===== Do's ===== | ===== Do's ===== | ||
- | [[.: | + | * [[.: |
- | [[.: | + | |
+ | * [[.: | ||
===== Don'ts ===== | ===== Don'ts ===== | ||
- | [[.: | + | * [[.: |
+ | * [[.: | ||
===== Stumbling Blocks ===== | ===== Stumbling Blocks ===== | ||
- | [[.: | + | * [[.: |
+ | * [[.: | ||
- | ===== Switch Block Switches Automatically ===== | ||
- | There are cases were a switch block has to switch to a certain input under given conditions. While it might be possible to use the safety system to check this condition it might be preferable if the switch block itself switches when a certain condition is met. To use the sequencer for this purpose is generally not advisable as realtime cannot be met there. \\ | ||
- | For further information refer to [[eeros_architecture: | ||
===== Block with Parameters ===== | ===== Block with Parameters ===== | ||
Situation: inner states of blocks can be changed only through signals or getter / setter methods. How to implement a slowly changing inertia matrix? You do not want to calculate this matrix out of regular signals with full speed. Solution: use slow time domain for this purpose and change ... | Situation: inner states of blocks can be changed only through signals or getter / setter methods. How to implement a slowly changing inertia matrix? You do not want to calculate this matrix out of regular signals with full speed. Solution: use slow time domain for this purpose and change ... | ||
- | ===== How to Stop a System with CTRL-C ===== | + | [[.:abort]] |
===== How to interact between Sequencer and Control System ===== | ===== How to interact between Sequencer and Control System ===== | ||
Seq soll signale in CS setzen (const) oder lesen \\ | Seq soll signale in CS setzen (const) oder lesen \\ | ||
- | ===== Comparisons of Safety Level do not Work ===== | + | |
- | addLevel forgotten \\ | + |
getting_started/practical_problems/start.txt · Last modified: 2018/04/17 14:54 by graf