Real-Time Robotics Framework

User Tools

Site Tools

You are here: EEROS Wiki » Get Started Using EEROS » Tutorials » Control a Single Motor
getting_started:tutorials:oneaxis

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
Last revisionBoth sides next revision
getting_started:tutorials:oneaxis [2021/03/30 09:49] – [Develop your own Application Further] ursgrafgetting_started:tutorials:oneaxis [2023/04/13 11:28] – [Build Application] ursgraf
Line 29: Line 29:
 =====Build Application===== =====Build Application=====
  
-  - Setup your system as described in [[getting_started:install|]]. Make sure that the entry in ''config.sh.in'' is set as follows <code> +  - Proceed with [[getting_started:write_app|]] and select the right target. Scroll down to ''Use Existing Project''.
-custom_application=simple-motor-control +
-</code> +
-  - Proceed with [[getting_started:write_app|]] for your target.+
   - After cloning with the clone script, navigate to the directory ''simple-motor-control'' where you can find the code of the application.   - After cloning with the clone script, navigate to the directory ''simple-motor-control'' where you can find the code of the application.
   - [[getting_started:deploy|]] to the target system if necessary.   - [[getting_started:deploy|]] to the target system if necessary.
getting_started/tutorials/oneaxis.txt · Last modified: 2023/04/13 11:29 by ursgraf