Differences

This shows you the differences between two versions of the page.

--- tools:singlestepping [2017/10/01 18:03] – [EEROS Application] graf
+++ tools:singlestepping [2019/03/14 09:34] (current) – [Single Stepping] graf
@@ Line 11: / Line 11: @@
 ===== Single Stepping =====
-On the machine where you wish to control your application sequences you have to install EEROS. Next, navigate to the directory ''tools'' in your build directory of the EEROS library. Run ''sequencerUI'' to remotely connect by typing
+On the machine where you wish to control your application sequences you have to install EEROS. Next, navigate to the directory ''tools/sequencer'' in your build directory of the EEROS library. Run ''sequencerUI'' to remotely connect to the machine running your EEROS application and pass its ip-address as a parameter.
 <code>
-$ ./sequencerUI "ip-
+$ ./sequencerUI -i "146.136.10.7"
+$ ./sequencerUI -i "localhost"  // if the EEROS application runs on the same machine
 </code>
+After starting you will be prompted for your input.
+<code>
+$ Enter 's' for single step, 'c' for continue, 'b' for break:
+</code>
+Entering the character 'b' will turn single stepping on and stop the execution of steps. 's' will execute the next step. 'c' will turn single stepping off. \\
+If you want your EEROS application to switch to single stepping mode upon startup you can do so with
+<code>
+  sequencer.singleStepping();
+</code>