Real-Time Robotics Framework

User Tools

Site Tools

You are here: EEROS Wiki » Tools for EEROS » Single Stepping of Sequences
tools:singlestepping

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
tools:singlestepping [2019/03/14 09:33] – [Single Stepping] graftools:singlestepping [2019/03/14 09:34] (current) – [Single Stepping] graf
Line 13: Line 13:
 On the machine where you wish to control your application sequences you have to install EEROS. Next, navigate to the directory ''tools/sequencer'' in your build directory of the EEROS library. Run ''sequencerUI'' to remotely connect to the machine running your EEROS application and pass its ip-address as a parameter.  On the machine where you wish to control your application sequences you have to install EEROS. Next, navigate to the directory ''tools/sequencer'' in your build directory of the EEROS library. Run ''sequencerUI'' to remotely connect to the machine running your EEROS application and pass its ip-address as a parameter. 
 <code> <code>
-$ ./sequencerUI "146.136.10.7" +$ ./sequencerUI -i "146.136.10.7" 
-$ ./sequencerUI "localhost"  // if the EEROS application runs on the same machine+$ ./sequencerUI -i "localhost"  // if the EEROS application runs on the same machine
 </code> </code>
 After starting you will be prompted for your input. After starting you will be prompted for your input.
tools/singlestepping.1552552416.txt.gz · Last modified: 2019/03/14 09:33 by graf