eeros_architecture:control_system:available_blocks:transition
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
eeros_architecture:control_system:available_blocks:transition [2017/12/07 17:40] – [Interpolator] graf | eeros_architecture:control_system:available_blocks:transition [2017/12/07 17:45] – [Filter] graf | ||
---|---|---|---|
Line 37: | Line 37: | ||
</ | </ | ||
+ | You can configure the transition block in such a way, that it does not filter. In this case, each time the faster output block runs, it takes its signal directly put through to the output. The output signals follows the input signal whithout any interpolation. You can choose this behavior with setting the '' | ||
+ | <code cpp> | ||
+ | Transition< | ||
+ | </ | ||
eeros_architecture/control_system/available_blocks/transition.txt · Last modified: 2021/02/10 15:40 by ursgraf