eeros_architecture:control_system:available_blocks:transition
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
eeros_architecture:control_system:available_blocks:transition [2017/12/07 17:47] – [Filter] graf | eeros_architecture:control_system:available_blocks:transition [2017/12/07 17:47] – [Interpolator] graf | ||
---|---|---|---|
Line 17: | Line 17: | ||
</ | </ | ||
- | You can configure the transition block in such a way, that it does not interpolate. In this case, each time the slower input block runs, its signal is directly put through to the output. The output signals follows the input signal | + | You can configure the transition block in such a way, that it does not interpolate. In this case, each time the slower input block runs, its signal is directly put through to the output. The output signals follows the input signal |
<code cpp> | <code cpp> | ||
Transition< | Transition< |
eeros_architecture/control_system/available_blocks/transition.txt · Last modified: 2021/02/10 15:40 by ursgraf