Differences

This shows you the differences between two versions of the page.

--- getting_started:practical_problems:faults_cs [2017/09/24 16:30] – created graf
+++ getting_started:practical_problems:faults_cs [2018/05/31 14:48] – graf
@@ Line 1: / Line 1: @@
 ===== Handle Faults in the Control System =====
-input not connected, forget to connect
+When a time domain runs, it can encounter two main obstacles. It could try to read from an unconnected input or it could try to write the value of ''nan'' to an output. If either of this happens a fault is thrown. Such a fault will cause the application to stop unless it is properly handled in the control system, e.g. by changing into a safe level, see [[eeros_architecture:control_system:time_domains|]].
+sinput not connected, forget to connect
 nan
 initial signals = nan, forget to addBlock
 remove block