getting_started:tutorials:oneaxis_bbb
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
getting_started:tutorials:oneaxis_bbb [2019/10/14 17:10] – [Ready Signal] graf | getting_started:tutorials:oneaxis_bbb [2019/10/14 17:21] – [Enable Signal] graf | ||
---|---|---|---|
Line 10: | Line 10: | ||
===== Enable Signal ===== | ===== Enable Signal ===== | ||
- | On the Beaglebone blue we do not use a motor controller and therefore, we do not use this signal. | + | On the Beaglebone blue we do not use a motor controller and therefore, we do not use this signal. However, we put the signal onto the green led on the board. |
===== Encoder Inputs ===== | ===== Encoder Inputs ===== | ||
Line 20: | Line 20: | ||
===== Ready Signal ===== | ===== Ready Signal ===== | ||
- | * motor controller | + | The ready signal |
===== Emergency Signal ===== | ===== Emergency Signal ===== | ||
+ | The emergency signal is used to bring the application in a safe mode. We put this input signal on a digital input pin which is connected to the on board push button //Pause//. Later when the application runs | ||
* emergency button to a digital input | * emergency button to a digital input | ||
getting_started/tutorials/oneaxis_bbb.txt · Last modified: 2021/02/12 17:22 by ursgraf