getting_started:tutorials:oneaxis_bbb
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| getting_started:tutorials:oneaxis_bbb [2019/10/14 17:21] – [Enable Signal] graf | getting_started:tutorials:oneaxis_bbb [2019/10/14 17:21] – [Emergency Signal] graf | ||
|---|---|---|---|
| Line 24: | Line 24: | ||
| ===== Emergency Signal ===== | ===== Emergency Signal ===== | ||
| - | The emergency signal is used to bring the application in a safe mode. We put this input signal on a digital input pin which is connected to the on board push button //Pause//. Later when the application runs | + | The emergency signal is used to bring the application in a safe mode. We put this input signal on a digital input pin which is connected to the on board push button //Pause//. Later when the application runs we can cause the safety system to switch to an emergency |
| - | + | ||
| - | * emergency button | + | |
| - | + | ||
getting_started/tutorials/oneaxis_bbb.txt · Last modified: 2021/02/12 17:22 by ursgraf