getting_started:tutorials:oneaxis_bbb
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| getting_started:tutorials:oneaxis_bbb [2021/02/12 15:23] – [Analog Output] ursgraf | getting_started:tutorials:oneaxis_bbb [2021/02/12 15:23] – [Encoder Inputs] ursgraf | ||
|---|---|---|---|
| Line 15: | Line 15: | ||
| There are 4 connectors denoted with //4 Quadrature encoder inputs//. Connect number 1 with your encoder. Make sure that your encoder works with 3.3V as delivered by this connector. Test the encoder with | There are 4 connectors denoted with //4 Quadrature encoder inputs//. Connect number 1 with your encoder. Make sure that your encoder works with 3.3V as delivered by this connector. Test the encoder with | ||
| < | < | ||
| - | debian@beaglebone:$ rc_test_encoders | + | ost@bblue:$ rc_test_encoders |
| </ | </ | ||
| Turning the motor in positive direction must lead to the encoder counting upwards. If not, change the A and B signal. | Turning the motor in positive direction must lead to the encoder counting upwards. If not, change the A and B signal. | ||
getting_started/tutorials/oneaxis_bbb.txt · Last modified: 2021/02/12 17:22 by ursgraf