User Tools

Site Tools


getting_started:tutorials:oneaxis_bbb

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
Last revisionBoth sides next revision
getting_started:tutorials:oneaxis_bbb [2021/02/12 15:23] – [Analog Output] ursgrafgetting_started:tutorials:oneaxis_bbb [2021/02/12 15:23] – [Encoder Inputs] ursgraf
Line 15: Line 15:
 There are 4 connectors denoted with //4 Quadrature encoder inputs//. Connect number 1 with your encoder. Make sure that your encoder works with 3.3V as delivered by this connector. Test the encoder with There are 4 connectors denoted with //4 Quadrature encoder inputs//. Connect number 1 with your encoder. Make sure that your encoder works with 3.3V as delivered by this connector. Test the encoder with
 <code> <code>
-debian@beaglebone:$ rc_test_encoders +ost@bblue:$ rc_test_encoders 
 </code> </code>
-Turning the motor in positive direction must lead to the encoder counting upwards. If not, change the A and B signal.+Turning the motor in positive direction must lead to the encoder counting upwards. If not, change the A and B signals.
  
 ===== Ready Signal ===== ===== Ready Signal =====
getting_started/tutorials/oneaxis_bbb.txt · Last modified: 2021/02/12 17:22 by ursgraf