Real-Time Robotics Framework

User Tools

Site Tools

You are here: EEROS Wiki » Get Started Using EEROS » Tutorials » Experimental Setup with a PC with National Instruments Card
getting_started:tutorials:oneaxis_comedi

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision		Previous revision
Last revisionBoth sides next revision
getting_started:tutorials:oneaxis_comedi [2019/10/12 19:27] – created grafgetting_started:tutorials:oneaxis_comedi [2019/10/16 09:03] – graf
Line 1: Line 1:
 +====== Experimental Setup with a PC with National Instruments Card ======
 +The host must be equipped with a data acquisition plug-in board. A maxon motor controller (50V / 5A) delivers the necessary power. 
 +
 +
   * A regular PC (x86-64) together with a National Instrument card: PCIe - 6251 (M-Series). The card requires the //comedi// library together with the EEROS hardware wrapper, see [[eeros_architecture:hal:hardware_libraries#comedi|]]. In any case you have to install ''comedi'' separately.   * A regular PC (x86-64) together with a National Instrument card: PCIe - 6251 (M-Series). The card requires the //comedi// library together with the EEROS hardware wrapper, see [[eeros_architecture:hal:hardware_libraries#comedi|]]. In any case you have to install ''comedi'' separately.
 {{ oneAxis_setup.png?688 |}} {{ oneAxis_setup.png?688 |}}
getting_started/tutorials/oneaxis_comedi.txt · Last modified: 2019/10/16 09:05 by graf