getting_started:tutorials:oneaxis_comedi
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| getting_started:tutorials:oneaxis_comedi [2026/05/27 15:40] – ursgraf | getting_started:tutorials:oneaxis_comedi [2026/05/28 14:22] (current) – [Run Application] ursgraf | ||
|---|---|---|---|
| Line 14: | Line 14: | ||
| IMPORTANT Make sure that a positive voltage on the motor leads to the encoder counting upwards. If the opposite is the case, either change the cables or change the hardware configuration file. \\ | IMPORTANT Make sure that a positive voltage on the motor leads to the encoder counting upwards. If the opposite is the case, either change the cables or change the hardware configuration file. \\ | ||
| + | |||
| + | =====Run Application===== | ||
| + | |||
| + | Start the application by choosing the appropriate configuration file: | ||
| + | < | ||
| + | $ sudo ./ | ||
| + | </ | ||
getting_started/tutorials/oneaxis_comedi.1779889244.txt.gz · Last modified: by ursgraf